MCINTOSH MT 10
Turntable
Code: 90434731
All our products are covered by Italian warranty.
With tracking force, anti-skate and cartridge position preset at the factory, the McIntosh MT10 delivers high performance LP playback with minimal set up. A custom tonearm features a rigid, dural-aluminum arm-tube gimbaled in two sapphire (horizontal) and two ceramic (vertical) bearings for the least possible friction. A .5mV moving coil cartridge is included, and features an ebony body with an elliptical stylus. Enjoy a new level of music with the MT10 turntable. This source component will help make your home theater system even better.
CARTRIDGE SPECIFICATIONS
CARTRIDGE TYPE Moving Coil, Low Output
OUTPUT LEVEL 0.5 mV at 5 cm/s
LOAD IMPEDANCE 400 to 500 Ω recommended
FREQUENCY RESPONSE 20Hz to 50kHz
CHANNEL SEPARATION Greater than 30dB at 1Khz
COMPLIANCE 6 x 10-6 cm/dyne
RECOMMENDED TRACKING FORCE 2.4 g
CHANNEL DIFFERENCE Less than 0.3 dB at 1kHz
TOTAL MASS 11 g
STYLUS Elliptical Diamond
CANTILEVER MATERIAL Aluminum
TONEARM SPECIFICATIONS
BEARING Sapphire and Ceramic
ARM TUBE Dural-Aluminum
COUNTERWEIGHT Eccentric
ADJUSTMENTS VTA, Antiskate, Azimuth
TURNTABLE SPECIFICATIONS
PLAYBACK SPEEDS 33 1/3, 45 and 78 rpm
MOTOR TYPE DC Brushless
SPEED CONTROL Electronic w/ braking feature
PLATTER Silicon Acrylic
PLATTER BEARING Magnetic Suspended Ceramic
CONNECTIVITY
STEREO OUTPUTS UNBALANCED 1
CONTROL
POWER CONTROL INPUT Yes
POWER CONTROL OUTPUT Yes
PLATTER LIGHT Yes
SPEED CONTROL FINE ADJUSTMENT Yes
GENERAL SPECIFICATIONS
DUST COVER No
WEIGHTS & DIMENSIONS
DIMENSIONS (W X H X D) 17-1/2" (44.45cm) x 8-13/16" (22.38cm) x 21" (53.34cm)
Note: Tone Arm Height will vary depending on the type of Cartridge installed.
WEIGHT 42 lbs (19 kg)
SHIPPING WEIGHT 63 lbs (28.6 kg)



